A brake drags / the wheel locks or overheats on a Ducati Multistrada V2 2026

Seized cable / drum brake

Heads up -- braking is a safety-critical system: if in any doubt, don't ride and get it checked. Confirmed diagnosis: on a drum brake (common on the rear of small bikes, cruisers, and many scooters/older models), a seized control cable or seized expansion cams keep the brake shoes partially extended -- the brake drags, overheats, and the wheel won't spin freely. Unlike a hydraulic disc brake, a drum brake is mechanically actuated (cable or rod): the lever/pedal pulls a cable that rotates a cam, spreading two lined shoes against the inside of the drum. Over time, the cable can seize inside its housing (corrosion, lack of lubrication), the return spring can weaken, or the cam pivots can corrode: the shoes stop retracting cleanly. The approach: lubricate or replace the cable, clean and lightly grease the cam pivots (never any grease on the linings or the drum's friction surface), check the return springs, and adjust the free play. This is an intermediate-level, purely mechanical job (no hydraulics involved). Risk level: moderate, on a vital component. Budget: a brake cable runs roughly 10 to 30 euros, cable lubricant and grease a few euros. Important: never put lubricant on the linings or the braking surface, and confirm the shoes retract cleanly after the fix. This tool helps you understand what's going on -- it doesn't replace a certified mechanic.

How to make the repair yourself

🟡 Intermediate level: a few basic tools and a bit of method are all you need. Work with a cold engine, take your time, and don't hesitate to stop the moment you're unsure.

1. 1Heads up -- keep the bike stable, brake cold. Confirm the diagnosis: with the wheel raised, it brakes on its own or turns stiffly, and the brake control doesn't return cleanly. Braking is vital: if in doubt, hand the job to a professional.
2. 2First check the control cable: work the lever/pedal and see if the cable slides and returns freely. A seized housing or corroded cable gives a soft or stuck return.
3. 3Loosen and lubricate the cable (cable lubricant, working it back and forth to spread the product). If it's frayed, rusted, or still won't slide despite lubrication, replace it with a cable of the correct length.
4. 4If the problem persists, remove the wheel and the drum brake backing plate to access the shoes and cams. Note the layout (take a photo) and the order of the springs.
5. 5Clean the inside of the drum and the linings dry (cloth, brake cleaner) -- brake dust can be harmful, avoid breathing it in. Never use any oily product on the linings or drum surface.
6. 6Clean and LIGHTLY grease, with a suitable grease, only the cam pivot points and the cam-to-shoe contact points, never anywhere near the friction surfaces. Check the return springs and replace them if they're worn out.
7. 7Reinstall the backing plate and wheel (axle torqued to spec), then adjust the control's free play: there should be a bit of slack before the brake engages, so the shoes can fully retract at rest.
8. 8With the wheel raised, confirm it now spins freely and the brake returns cleanly. Do a gradual test ride. If you have any doubt about brake performance or return, have it checked by a professional.